Course Objectives

Important University Policies

Class Time and Place

Prerequisites

Blackboard

;

This page is the general description of the course and suggested expectations for both the student and the expectations of the teacher.

Variable Point Sampling

Formated version of this page for printing

Point sampling or variable plot sampling is based on the idea that every tree size has a different size plot all centered on a point. The plot extent is usually measured with a angle gauge. The angle gauge can be mechanical (e.g., angle spanning gauges), optical (e.g., prisms), or a combination (e.g., relaskop).

The following figure illustrates how a prism is used on level ground to determine if a tree is in or out of the plot. Border trees can greatly influence the statistics collected from the sample so it is recommended to measure all border trees and compare against a limiting distance table.

This table can be calculated using the formula for plot radius below and a spreadsheet. Limiting distances are measured from plot center to the center of the tree.

Figure 1. Illustration of the view through a glass prism.

The following diagram illustrates what the prism is doing and how the image is displaced by the prism. Please note that the apexes of different angle gauges are different. The apex should be held over plot center. With optical gauges the apex is the device it self. With mechanical gauges, it is your eye.

Figure 2. Description of the geometry of the prism optical displacement.

If using an angle gauge on a slope you must correct for the slope in the direction you are looking. That means up and down slope you correct, looking side slope you do not correct. The way to slope correct with a prism is by turning the prism at an angle parallel to the slope along which

you are looking. Again, when in doubt, measure the distance to the tree and compare to a table of limiting distances.